You Are Here: Home » Projects

Interfacing NFC PN532 Using ESP8266 With LINE Push Notification

In this article , we will read NFC tag using NFC reader PN532 module and ESP8266 , Then send automatic push notification to a smart phone using line mobile application. Sounds Interesting, Then enjoy the tutorial. Don't forget to leave your feedback, at end of this tutorial in comment section below. Basic Block Diagram Of this Project Hardware Needed: nodeMCU(base on esp8266) PN532 NFC module NTAG Jumper wi ...

Read more

Esp8266 Wifi Based Beverage notification On Smart Phone

This article proposes notifications for your Internet of Things devices. it's will help you to hack your doorbell to send Push notification to mobile and laptop when somebody‚Äôs open the door. It use the free PushingBox service to delegate all the programming part and make things easy. All this in real time.   Hardware Needed nodeMCU(base on esp8266) Jumper wire Limit switch Software Needed PushingboxAP ...

Read more

Atmel QTouch Sensor Based Home Automation

In this article, I would like to tell you about my current project which is a Touch Sensor based Home automation system, built using Atmel QTouch. Atmel QTouch (AT42QT1011) are really impressive  dedicated capacitive touch sensor, which don't need any external microcontroller to operate, which reduces cost and size of products. Before Moving Into article , I Would like to show you the demo , which I have in ...

Read more

Physical Shutdown Button For Raspberry Pi

Sometimes I wondered, there should be a physical shutdown button on raspberry pi, to safely down the device, because direct shutdown of raspberry pi could damage the SD card or File system. So I had added of my own. Here is how. Image Raspberry Pi Looks Like Below. Steps: I added a push button to BCM GPIO 23. Another end of Push button to the 3.3V that is Pin Number One. Schematic: write two code, one is py ...

Read more
Scroll to top