Interfacing Ethernet with Mircrocontroller – Arduino and ENC28j60 Reviewed by Momizat on . This video will guide you to interfacing enc28j60 Ethernet module with arduino uno /nano. ENC28J60 is a SPI module. Its very simple to interfacing with ether ca This video will guide you to interfacing enc28j60 Ethernet module with arduino uno /nano. ENC28J60 is a SPI module. Its very simple to interfacing with ether ca Rating:
You Are Here: Home » IOT » Interfacing Ethernet with Mircrocontroller – Arduino and ENC28j60

Interfacing Ethernet with Mircrocontroller – Arduino and ENC28j60






This video will guide you to interfacing enc28j60 Ethernet module with arduino uno /nano. ENC28J60 is a SPI module. Its very simple to interfacing with ether card library.
Connection Between ENC28J60 Ethernet Module and Arduino is as follows.

 


ENC28J60 | Arduino UNO
——————————————-
VCC 3.3V
GND GND
SCK Pin 13
SO Pin 12
SI Pin 11
CS Pin 8

Link To download Ether card library: http://jeelabs.org/pub/docs/ethercard/

EtherCard is a library that performs low-level interfacing with network interfaces based on the MicroChip (C) ENC28J60. High-level routines are provided to allow a variety of purposes including simple data transfer through to HTTP handling. EtherCard is a driver for the ENC28J60 chip, compatible with Arduino IDE.

For complete step my step guide click here: https://myelectronicslab.com

Hope this tutorial helps to make some awesome, IOT projects.

About The Author

I am a maker, who loves to think, hack and build new electronics stuff, I always find time to document , share my knowledge with others. I am graduate in BTech(Electronics and Communication Engineering).

Number of Entries : 40
Scroll to top